Glossary

From CommercialEspressoMachine.wiki, the commercial coffee equipment encyclopedia

The glossary defines 35 terms used in this wiki's equipment articles. Each term links to the equipment that uses it.

A

Airpot
An airpot is a vacuum-insulated pump-action server that keeps brewed coffee hot without a heater.
Automatic tamper
An automatic tamper compresses the coffee in the portafilter with a set, repeatable force at the push of the portafilter. See automatic espresso tampers .
Autosteam
Autosteam is an automatic steam wand that heats and froths milk to a programmed temperature and then shuts off, using a temperature probe in the pitcher.

B

Batch brewer
A batch brewer brews a full batch of drip coffee at once into a server, airpot or decanter. See commercial coffee brewers .

C

Conical burrs
Conical burrs are a cone-shaped inner burr turning inside a ring-shaped outer burr. Conical burrs can run at lower speeds than flat burrs of the same output.

D

Direct connect (plumbed)
A direct-connect or plumbed machine takes water from a pressurized water line and drains to a floor or sink drain. Most commercial espresso machines and brewers are plumbed.
Doser grinder
A doser grinder grinds coffee into a chamber with a sweeping lever that drops pre-measured portions into the portafilter.
Dual boiler
A dual boiler espresso machine has one boiler for brew water and a separate boiler for steam and hot water. Separating the two lets the brew temperature be set independently of steam pressure.

F

Flat burrs
Flat burrs are two parallel, ring-shaped grinding discs; one turns while the other stays fixed. Burr diameter is quoted in millimeters, and larger burrs grind faster.

G

Grind by weight
Grind by weight (GBW) means the grinder weighs each dose with a built-in scale and stops at a target weight, instead of grinding for a set time.
Grinder retention
Retention is the ground coffee left inside a grinder's burr chamber and chute after a dose. Low-retention grinders waste less coffee and serve fresher doses.
Group head
A group head is the part of an espresso machine where the portafilter locks in and hot water is released over the coffee. A machine's group count is the number of group heads it has, and each group head brews one or two shots at a time.

H

Heat exchanger
A heat exchanger is a tube that runs fresh brew water through the steam boiler, heating it on the way to the group head. Heat-exchanger machines brew and steam at the same time from one boiler, which is why the design is common on commercial espresso machines.

L

Lever espresso machine
A lever espresso machine builds brewing pressure with a spring-loaded piston that the barista loads by pulling a lever, instead of an electric pump. Pressure falls gradually as the spring extends.
Limescale
Limescale is the mineral deposit (mostly calcium carbonate) that hard water leaves inside boilers, pipes and heating elements. Scale is the most common cause of boiler and element failure in coffee equipment.

M

Multi-boiler
A multi-boiler espresso machine gives each group head its own brew boiler, plus a steam boiler. Each group can then run at its own temperature, which lets a café pull different coffees at different temperatures side by side.

N

NEMA receptacle
A NEMA receptacle is a North American plug-and-socket type defined by the National Electrical Manufacturers Association. Common commercial coffee equipment types are NEMA 5-15 and 5-20 (120 V), NEMA 6-20 and 6-30 (250 V), and NEMA 14-30 (120/240 V). The receptacle must match the machine's plug and t
Nitro cold brew
Nitro cold brew is cold brew coffee infused with nitrogen gas and poured from a tap, which gives it a creamy body and a foam head.
NSF certification
NSF certification means a piece of food equipment has been tested by NSF International against its sanitation and food-safety standards. Health inspectors in many U.S. jurisdictions expect commercial food equipment to carry NSF or an equivalent listing.

O

On-demand grinder
An on-demand grinder grinds one dose straight into the portafilter when the barista starts it, instead of filling a doser chamber in advance. Doses are set by time or by weight.

P

PID controller
A PID controller is an electronic thermostat that holds boiler temperature on target by adjusting the heating element continuously, instead of switching it fully on and off.
Portafilter
A portafilter is the handled basket holder that carries ground coffee into the group head . Commercial portafilters are usually 58 mm, and the basket size sets the dose.
Pour-over (reservoir)
A pour-over or tank-fed machine draws water from a built-in reservoir that staff refill by hand, so it runs without a water line. Mobile carts and catering setups use pour-over machines.
Pre-infusion
Pre-infusion is a short, low-pressure wetting of the coffee puck before full brewing pressure is applied. It lets the coffee bed settle evenly and reduces channeling.

R

Rotary pump
A rotary pump is a motor-driven vane pump that delivers steady pressure and can run continuously. Plumbed commercial espresso machines use rotary pumps.

S

Satellite server
A satellite server is a portable coffee server that sits under a brewer during brewing and then moves to a heated base or service counter.
Saturated group
A saturated group is a group head that is filled with water from the brew boiler and bolted directly to it, so the group stays at boiler temperature. The design keeps brew temperature stable from shot to shot.
Semi-automatic
A semi-automatic espresso machine starts and stops the pump with a switch or paddle that the barista controls. There is no flow meter, so shot volume depends on the barista.
Single-phase power
Single-phase power at 208–240 V is the electrical service most two- and three-group espresso machines and high-wattage brewers require in the United States. It is supplied on a dedicated circuit sized to the machine's amperage.
Steam wand
A steam wand is the pipe that releases steam from the steam boiler to heat and texture milk. Cool-touch wands stay cool on the outside; automatic steam wands stop at a set milk temperature.
Superautomatic
A superautomatic machine grinds, doses, tamps, brews and dispenses espresso drinks automatically from whole beans. See superautomatic espresso machines for every model in this wiki.

U

UL and ETL listing
UL and ETL listings show that an electrical appliance has been tested for electrical safety by a Nationally Recognized Testing Laboratory. Both marks are accepted for commercial equipment in the United States.

V

Vibratory pump
A vibratory pump is a small electromagnetic pump that builds pressure with a vibrating piston. It is common on compact and pour-over machines because it is small and draws from a tank.
Volumetric dosing
Volumetric dosing is a control system that stops each espresso shot after a programmed volume of water, measured by a flow meter. Volumetric machines have programmable buttons for single, double and continuous shots, so every barista pours the same volume.

W

Water filtration
Water filtration for coffee equipment removes chlorine, sediment and hardness minerals before water reaches the boiler. Softening or scale-inhibiting filters protect boilers and heating elements from limescale .